China has moved a step closer to electric regional aviation. The CE-25A, a 19-seat aircraft developed by the state-owned Commercial Aircraft Corporation of China (COMAC), completed its first piloted flight on 14 November 2026. It is a striking milestone — but not yet proof that battery-powered passenger flights are commercially viable.
- A first piloted flight — not a commercial launch
- What exactly is the CE-25A?
- The battery question is the biggest unanswered one
- Why 400 kilometres is both promising and limiting
- China is not starting from zero — and it is not alone
- What would make the CE-25A a genuine breakthrough?
- The bigger picture
- Sources and further reading
The aircraft is unusual even before it leaves the ground. Instead of two conventional turboprop engines, it uses ten electrically driven ducted fans mounted along its wings. COMAC says it is designed for short intercity journeys, with a range of up to 400 kilometres. The crucial questions are what that range means in real operating conditions, what batteries are installed, and how far the project is from carrying paying passengers.
A first piloted flight — not a commercial launch
The CE-25A flew at Binzhou in China’s Shandong province on 14 November. Two pilots and a flight-test engineer were on board. According to the Civil Aviation Administration of China (CAAC), the aircraft spent 16 minutes and 38 seconds in the air and covered about 60 kilometres. The complete test, including ground operations, lasted 57 minutes and 46 seconds.
That distinction matters. The aircraft had already completed its first unmanned autonomous flight on 2 February 2026, followed by 19 unmanned flight validations. The November flight was the first time people were aboard — a meaningful advance in the test programme, but a relatively short test compared with the aircraft’s advertised 400-kilometre range.
The CAAC says it has accepted COMAC’s application for a type certificate. This means the formal airworthiness assessment can proceed; it does not mean the aircraft has been certified, approved for airline use or cleared to carry fare-paying passengers. No commercial entry-into-service date has been announced.
Sources: Civil Aviation Administration of China, 16 November 2026; AeroTime, 15 November 2026.
What exactly is the CE-25A?
COMAC describes the CE-25A as a ten-tonne-class electric commercial aircraft intended mainly for intercity transport. Its published headline specifications are:
| Specification | Published figure |
|---|---|
| Passenger capacity | 19 |
| Maximum take-off weight | 10 tonnes |
| Claimed range | 400 km |
| Cruising speed | 300 km/h |
| Cruising altitude | 2,400 metres |
| Propulsion | 10 electric ducted fans |
Five fans are mounted on each wing. This arrangement is an example of distributed electric propulsion: instead of concentrating thrust in one or two large engines, a number of smaller electric propulsion units are spread across the aircraft. Electric motors can be controlled precisely and the arrangement gives designers new options for integrating propulsion with the wing. Whether this particular layout delivers a decisive efficiency or operating advantage will need to be demonstrated through testing and service data.
The figures above are published design specifications, not a complete independently verified performance record. COMAC has not publicly provided the detailed test conditions behind the 400-kilometre range — including payload, weather, reserve policy, battery state at landing or the amount of energy used.
The battery question is the biggest unanswered one
Battery technology is the central constraint on larger electric aircraft. Aviation fuel stores far more usable energy per kilogram than today’s batteries. Electric motors are much more efficient than combustion engines, which narrows the gap, but batteries still have to be carried for the entire flight and cannot be made lighter by burning fuel as the journey progresses.
COMAC says the CE-25A was developed with Chinese battery manufacturer CATL, Shanghai Jiao Tong University and other partners. CATL has previously publicised a so-called condensed battery with a claimed cell-level energy density of up to 500 watt-hours per kilogram, saying the technology could open the way to passenger aircraft electrification.
That announcement should not be mistaken for confirmation of what is installed in the CE-25A. Neither COMAC nor CATL has publicly identified the aircraft’s battery chemistry, capacity, pack weight or pack-level energy density. A cell-level figure is also not the same as the performance of a complete aviation battery system, which needs casing, cooling, wiring, monitoring and protection.
The distinction is important because every kilogram devoted to batteries is a kilogram that cannot be used for passengers, luggage or other equipment. The aircraft must also retain sufficient energy for diversions, holding and other safety reserves. A published range figure is therefore not automatically the distance an airline could schedule with a full passenger load.
Sources: CATL’s 2023 condensed-battery announcement; NASA Glenn Research Center, electrified aircraft propulsion battery requirements.
Why 400 kilometres is both promising and limiting
A 400-kilometre design range could make sense for selected short regional routes, particularly where the alternative is a small aircraft operating between nearby cities. It is not comparable with the range of a conventional jet airliner, and it is shorter than the range offered by many established regional turboprops.
For an airline, the usable route distance would have to be calculated after allowing for passenger and baggage loads, weather, reserves, airport conditions, battery ageing and the time required to recharge. A route that looks possible on a map may not be practical every day, in both directions, with a reliable timetable.
Charging infrastructure is another part of the equation. Airports would need suitable high-power electrical connections, charging equipment, procedures for monitoring battery condition and contingency plans if an aircraft arrives with less energy than expected. Turnaround time matters: a plane that takes too long to recharge may need additional aircraft to operate the same timetable.
China is not starting from zero — and it is not alone
The CE-25A is not the world’s first electric aircraft, nor is it the first time researchers have tested multiple electric motors on a wing. What makes it notable is its size, its intended 19-passenger transport role and the fact that it has now flown with a crew.
NASA’s X-57 Maxwell programme in the United States explored distributed electric propulsion using 14 motors and propellers. It generated useful engineering research, but the aircraft never made its planned flight. NASA ended operational work in 2023 after unresolved hardware and component challenges prevented the team from reaching acceptable flight conditions within the programme’s timeframe.

Other companies are pursuing different approaches. Sweden’s Heart Aerospace has flown its X1 demonstrator as it develops a larger hybrid-electric regional aircraft concept. Hybrid designs retain fuel-burning generators or engines to extend range, while a battery-only aircraft must complete the entire mission using stored electrical energy. These projects are not direct equivalents, but they show that the industry is still testing several competing routes towards lower-emission aviation.
Sources: NASA TechPort — X-57 project close-out; NASA, lessons from the X-57 programme; Electrek, CE-25A and other electric-aircraft projects.
What would make the CE-25A a genuine breakthrough?
The first piloted flight demonstrates that the aircraft has reached an important stage of development. It does not yet answer the questions that determine whether it becomes a useful commercial product. The next evidence to watch for includes:
- Publication of the battery type, capacity, weight and safety architecture.
- Longer flights that demonstrate the claimed range under clearly stated conditions.
- Tests with representative passenger and baggage loads.
- Evidence about battery degradation, charging time and turnaround operations.
- Progress through type certification and the regulator’s airworthiness requirements.
- Airline customers, operating routes and a credible timetable for passenger service.
The bigger picture
Electric flight is unlikely to replace long-haul passenger jets in the foreseeable future. The weight of the batteries required for hundreds of passengers over thousands of kilometres remains a formidable obstacle. Short regional journeys are a more realistic starting point, provided the economics, range and charging arrangements work.
China’s CE-25A deserves attention because it takes electric aviation beyond small training aircraft and experimental prototypes into a 10-tonne, 19-seat design that has flown with people aboard. The country’s strong battery-manufacturing base and COMAC’s aerospace ambitions give the project strategic significance.
But the most important details are still missing. The battery has not been publicly specified, the 400-kilometre range has not been demonstrated in the piloted flight, and certification has only begun. For now, the CE-25A is a serious and interesting test programme — not an electric airliner ready to transform regional travel.
Sources and further reading
- Civil Aviation Administration of China — first piloted flight announcement
- CCTV / Xinhua — CE-25A flight report
- CATL — condensed battery announcement, 19 April 2023
- NASA TechPort — X-57 Maxwell project
- NASA Glenn Research Center — battery requirements for electrified aircraft
- AeroTime — technical reporting on the CE-25A flight
Image credits: CE-25A concept rendering by Helwikied, Wikimedia Commons, CC0 1.0 Public Domain Dedication. NASA X-57 image by the National Aeronautics and Space Administration, public domain (US government work). The CE-25A rendering is an illustration, not a photograph of the aircraft during its test flight.
